Repair and renew old doors to save big

July 28, 2015

If your home has doors that seem like they need replacing, hold on for a moment. Try these tips below to see if you can salvage the doors you have, and save yourself some money.

Repair and renew old doors to save big

Tighten a screen door

  • Wooden screen doors take a lot of abuse, especially when they are attached to a spring that slams them shut.
  • It's not surprising that they warp or suffer from loose joints. To straighten a warped screen door, install a tension rod with a turnbuckle diagonally across the door. Tighten the turnbuckle to pull the door flat.
  • To reinforce loose joints, you can use the strategies described below. Another easy, cheap, but less attractive solution is to use L-shaped steel mending plates.
  • Just put one mending plate across each joint on one side of the door, and fasten them down with the screws provided.

Add a combo door

  • Instead of replacing a nice old exterior door, you could add a storm-screen combination door.
  • Models with full-glass panels can show off a historic old door while protecting it from the weather.
  • A top-quality storm-screen door, however, can cost nearly as much as a new main door, but it's easier to install and will be just as airtight as a new door.

Peg loose door joints

  • On a traditional panelled door, the raised panel is in a frame consisting of horizontal rails and vertical stiles. Usually the rails have tongues called tenons that are glued into pockets called mortises in the stiles.
  • After many years of use, these mortise-and-tenon joints can become loose and separated. The fix is easy if you are getting ready to repaint the door.
  • Clamp the joints tightly closed. Drill a one-centimetre (1/2-inch) hole through the stiles at each corner so the holes will go through the mortises and tenons.
  • Put some yellow carpenter's glue in the holes; then tap in one centimetre (1/2 inch) in diameter hardwood dowels.
  • Cut the dowels flush on both sides, and sand smooth. Paint will hide the repair.

Add a brass plate

  • Alternately, another way to reinforce loose door joints is to screw on a brass plate that spans the bottom rail and the bottoms of the adjoining stiles.
  • Put one on both sides for extra strength. It's also a great way to protect the paint or finish on that door you tend to kick open when your arms are full of groceries.
The material on this website is provided for entertainment, informational and educational purposes only and should never act as a substitute to the advice of an applicable professional. Use of this website is subject to our terms of use and privacy policy.
Close menu